Please immediately check for any hidden damage that may have occurred in shipping. If any damage is found you must notify the delivering carrier within seven days. A few minutes with the following instructions will insure quick and proper assembly, and many years of enjoyment and relaxation. By reviewing all the instruction steps ahead of time, you will have a better feel for the whole process. Your sauna package will arrive on a stretch-wrapped pallet including a stack of pre-built panels, benches, and boxes with the heater and accessories.
Your sauna can be placed on concrete, tile, linoleum, or any surface that does not absorb water. Do not install the sauna on carpeting.
To o l s R e q u i r e d
710-0107 Panel Built Installation Rev. 01
•Hammer or pin nailer •Handsaw and mitre box (for molding installation & vent holes) •Drill or cordless screwdriver •Tape measure •Square •Level •3/8” wood bit (if sauna room has an L-bench) •3/4” wood bit (optional, see photo B2) •Note: Torx bit is provided
9/8/04 R.D. MW
Accessories
Duckboard Vent Valve
Note: Half of the groove has been removed for easy installation
Trim Profiles
Bench Electrical Access Board
Cove Molding
Window/Door Casing (normally pre-installed)
Door Handle
Inside Corner Molding
Vent Grill
Exterior Facia Trim (in some models)
Headrest
Backrest
Hardware Package
Outer 45 Deg. Corner Molding (on rooms w/more than 4 walls)
Inside 45 Deg. Corner Molding (on rooms w/more than 4 walls) Finishing Nails 2” Screws 1-1/2” Screws Carriage Bolts
(for saunas with L-benches)
3” Screws Torx Bit Wood Joiners
Washers & Nuts
710-0107 Panel Built Installation Rev. 01
1
9/8/04 R.D. MW
Facia Trim Ceiling Panel
Top Plate Interior Cove Molding Benches Exterior Corner Trim Wall Panel
Standard Panel-Built Sauna
Exploded Assembly
Base Frame Duckboard Floor
No comments