Operation Method of Drilling Mud Cleaner

Oilfield drilling fluids mud cleaner http://www.kosungroup.com/products/solids-control-equipment/mud-cleaner.html is the second or third stage drilling fluids solids control equipment in drilling fluids recycling system. This oil drilling fluids cleaner will handle the solids particle after being treated by the first grade separation equipment. The mud will be recovered and cuttings which are bigger than mud will be removed. Then the cuttings in the underflow will flow into circulation mud tanks through the screens of the oilfield drilling mud conditioner when the weighted mud passes while the particles that are bigger than mesh will be removed.

Mud cleaner should be paid attention to the following aspects in the operating process:

一、Hydrocyclones desander operation method

1. Before cyclone sewage pump starts, it must be installed on the suction side at the bottom of the screen, to prevent the particle mass into hydrocyclones;

2. The regulation of bottom LiuKou opening

a. Bottom flow should discharge solid phase particles is umbrella-shaped mist is preferred. This bottom flow state can be achieved by adjusting the opening of base flow. For example, the lower the input, the proportion of mud, bottom LiuKou opening should be smaller, and vice.

b. Check the underflow whether for fog method or not can inserted with the help of a finger from the bottom stream, it is advisable to feel the air inhaled hydrocyclone http://www.kosungroup.com/products/product-accessories/hydrocyclone.html. If the bottom flow shapes such as rope, should open outsole LiuKou, until the insert fingers felt the air suction.

3. Maintenance

A final hole after drilling, should do some maintenance work hydrocyclones for the as follows:

a. Comprehensive maintenance and repair of the hydrocyclones input pipe, overflow pipe and liner, etc.;

b. Lubrication bottom LiuKou adjusting screw;

c. Flushing the hydrocyclone with group circulation water, to prevent dry sand inside...