Ecet 340 Week 3 Homework 3

ECET 340 Week 3 HomeWork 3

Check this A+ tutorial guideline at
http://www.assignmentcloud.com/ecet-340devry/ecet-340-week-3-homework-3

1. Sketch a circuit that can be used to debounce a pushbutton and explain how it
works. (4 points max)
2. In Figure 7.32 on page 339 of the Huang textbook, if the row has and the
columnsare , which key is pressed? (2 points max)
3. In Figure 7.32 on page 339 of the Huang textbook, explain why the 10kΩ resistors
ties to VCC are required. (2 points max)
4. Write down the lines of C code (interrupt service routine, ISR) that generates an
interrupt when Port H pin 0 becomes a logic “1”. Within this ISR, disable interrupts,
clear the interrupt flag, then enable interrupts, and return from routine. I also want
the routine or lines of C code that initialize Port H pin 0 to be used as an interrupt
(hint: think data direction register) (2 points max)
5. Write down the C statements you would need to add to the main program of the
keypad driver program given in lecture and lab in order to store the key characters
to a buffer area of memory called keys_entered and exit the program as soon as
either seven keypresses are entered or the the “D” key is entered. (Counts as two
questions) (4 points max….you need to use arrays in C code)
6. State the functions of pins RS, E and R/W in the LCD. (4 points max)
7. Give the state of RS, E and R/W~, and the command code (in hex) for the 20th
location, line 2 on the 40x2 LCD described in lecture. (2 points max)

For more classes visit

http://www.assignmentcloud.com