Words of Wisdom:

"Cheese poofs remind me of a bird and a clean window....the glare confuses the bird and it hits the window really hard! " - Ytiema

The Ball Mill's Points Warehouse Upgrade Technology

  • Date Submitted: 05/23/2012 08:09 PM
  • Flesch-Kincaid Score: 55.6 
  • Words: 781
  • Essay Grade: no grades
  • Report this Essay
The ball mill's points warehouse upgrade technology_Ivylm522Sound insulation cover wall the composition of the board from inner to outer is as follows: 3 RRN thick plate, 6 nm thick drain clear stone cotton lint damping layer, 10 (~ en thick rock wool sound-absorbing board, spun glass cloth and 1 mm thick, perforation rate 30% of the principal part of the perforation panel. Cover plate thickness of the total for 11 firm. In the ends of the cover because of the self-contained tank tube end of the gap between less than 100 ram, cover board and not allowed and rotation tank have a contact, and therefore the place between the cover thickness for five (krma. Close to the shaft of the site because operation requirements often remove cover board, so this part of the cover plate is 4 ding m thick panels, with handles, may at any time off. Provide brand products within: the ball mill, the rotary kiln, mineral processing equipment, the grate ball mill and super fine ball mill. Noise control of ball mill is the most direct, the most effective, the most economic measure to reduce the sound source sound:' from the sound source control noise'. So reducing noise source noise is the development trend of the research on noise control of ball mill. ball mill: The ball mill is widely applied in mineral classification, cement, fireproof materials, glass, pottery, chemical industry and so on. The ball mill can grind all kinds of rocks and grinding materials. There are two ways of grinding: the dry process and the wet process.

Ball mill can be divided into lattice type and overflow type according to different beneficiation methods, and this machine is two lattice-type ball mill. The materials from the feeding fittings enter evenly to the first bin of the milling machine via the feeding hollow axis when it works. There is a ladder-like or ripple-like scaleboard in the first bin, and different specification steel balls are installed in the bin. When the cylinder rotates and produces...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments