Xingbang Crusher to Manufacture Thriving Enterprise Passes

XingBang crusher to manufacture thriving enterprise passes_Ivylm522shaker common problems in running Shaker common problems in running the shaker can not be started jaw crusher or amplitude is too small, Jaw Crusher should be considered first electrically have barrier-free, damage to the motor or circuit components for block machine damage, may also be less than the voltage at that time, if these three has had no jaw crusher problems, it would have to check from the machinery, the screen surface materials piled too much, and if so, shall be immediately removed.Because the accumulation of too much material will have a direct impact on the amplitude of the vibrating screen.Shaker with or without coupling bolts off,
Rotary Kiln:   http://www.china-xingbang.com/24.html
jaw crusher: http://www.china-xingbang.com/32.html                          
block machine:   http://www.china-xingbang.com/Brick-machine/82.html        
     
the grease thickens ball mill agglomeration, washable repair shaker, and then appropriate adjustments to the eccentric shaft heavier block or Vice eccentric position.During normal working hours, shaker rotating more slowly, bearing fever, in which case, the maintenance of peace did not keep up with, bearing the missing grease.If the bearing is added to oils, there may be quality problems or too Rotary Kiln full of fat, low-quality oil bearings so that blocking the labyrinth seal stuck, so the grease quality is very important.If the shaker during vibration screen noise is too large, it may be bearing damage, loose bolts, beams fracture and spring damage, apart from the bolt can be tightened, the other three conditions are required replacement parts. The correct operating procedures of the Ivylm522

jaw crusher:   http://www.xb-crusher.com
ball mill:   http://www.xingbangmills.com        
ball mill:   http://www.xb-machine.com/