Words of Wisdom:

"To the world,you may be one person;but to one person you may be the world!" - Jana

Impact Crusher Parts Strength Calculation

  • Date Submitted: 08/29/2012 02:47 AM
  • Flesch-Kincaid Score: 30.6 
  • Words: 544
  • Essay Grade: no grades
  • Report this Essay
Impact Crusher parts strength calculation
    Introduction: the precipitator accessories YMF-50 solenoid valve system abroad (also called diaphragm valve) is the pulse jet bag filter clean blowing compressed air system "switch" subject to the control of the pulse jet control device output signal, The resistance of the dust accessories jet dust filter bag-by-row (room), the precipitator is maintained within a set range, in order to ensure that the processing power and the collection efficiency of the precipitator.Technical Specifications: Working pressure: 0.4 to 0.7, the ambient temperature: -10 to 55 (),Hammer crusher the use of the medium: clean air,brick making machine diaphragm life: blowing more than 100 million times.Connecting thread: ZG2 ", length: 210, width: 190mm, height: 200 Weight: 2.8kg installation methods: electromagnetic pulse valve input end (IN), metal tube with air reservoir connected to its output with dust box blow tube connection, the connecting thread between are filled with tetrafluoroethylene raw material fastening seal.The pulsed solenoid valve the submerged valve (aka Embedded valves), it is mounted directly on the air bag has a good direct injection, a smaller loss of working gas source, suitable for a wide range of air supply pressure of the occasion.Working pressure: 0.2 to 0.6, the ambient temperature: -10 to 55 (), the use of the medium: clean air, diaphragm life: blowing more than 100 million times. Working principle:

  The solenoid valve has a sealed cavity, at different positions with holes, each hole leading to the different tubing cavity intermediate valve, two is two electromagnets, which face of the magnet coil is energized,brick making machine the valve body will be attracted to which side, by controlling the movement of the valve element to file live or leaked oil discharge hole, and the oil inlet is normally open, the hydraulic oil will enter a different discharge pipe, and   alicey599 then through the pressure of...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments