Words of Wisdom:

"fred vinall likes it up the chuff" - Angelicagates

The Newly Designed Vibrating Feeder

  • Date Submitted: 01/05/2013 12:17 AM
  • Flesch-Kincaid Score: 35.9 
  • Words: 332
  • Essay Grade: no grades
  • Report this Essay
     The structure of electromagnetic vibrating feeder is simple, and the device is easy to operate, there is no need to embellish it, power consumption is alos small; evenlyit can adjust the amount of ore; so it is widely used inmany fields.. The small electromagnetic vibrating feeders is generally applied for loose materials. 
Configuration design should be based on equipment performance requirements as far as possible. 
     Configuration should be designed according to the requirements of the equipment performance, minimize material tank pressure required by the manufacturer, Bunker effective discharge port shall not be greater than one-fourth of the slot width, material flow speed should be controlled 6-18m /min.
     For larger materials with feeding capacity, the silo bottom discharge should be set a sufficient height elam mine board; In order to not affect the performance of the feeder, the board shall be fixed in the tank. In order to smooth discharge for the silo, silo posterior wall inclination is designed of 55-65 degrees. 
     The application of electromagnetic vibrating feeder: electromagnetic vibrating feeder is generally used in the mining industry, electromagnetic vibrating feeder is a relatively new type of quantitative feeding equipment, electromagnetic vibrating feeder can adapt to continuous production requirements, it has been widely used in mining, metallurgy, coal and other industries.
1. Inertia the vibrating feeder Electrical control adopts a half-wave rectifier circuit, and it can be adjusted to the quantity, can be used for automatic control of the production process,  and finally achieve production process automation. 
2. No rotating parts, no lubrication, simple structure and easy maintenance.
3. Inertial vibration feeder material is micro-projectile motion, chute wear is small.
4. The chute of inertial vibration feeder made of alloy...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments