Words of Wisdom:

"wat is this life full of care if we have no time to stand and stare" - Baylake

The Working Load of Patent Mill Should Be Proper

  • Date Submitted: 06/09/2013 12:19 AM
  • Flesch-Kincaid Score: 47.7 
  • Words: 501
  • Essay Grade: no grades
  • Report this Essay
Raw material falls down into feed hopper, and then through ring, it is divided into two parts by material-dividing plate. One enters into impeller through the center of material-dividing plate. The other falls down from outside of material-dividing plate. Material, which is thrown out by impeller at speed of 60-75m/s hits material coming down from outside of material-dividing plate. In this way, material is crushed. Our company manufactures various kinds of sand maker and HX series impact crusher.The third generation sand maker manufactured by Hongxing Machinery is an advanced and efficient mining crusher machine that withstands the test of market, our sand manufacturing line equipment can process the rocks into 1 to 20 millimeters of fine sand and coarse sand according to customer needs. Especially on the most significant end such as high iron, highway construction site everywhere you can see thousands of cubic meters of the stone and sand stacks, of which the equipment used cannot lack the supply of Hongxing Machinery.Ball Millis are mainly used to grind materials in mineral, cement, refractory, chemical industry, etc. Ball Mill has dry and wet ways. When wet Ball Mill works, certain water and other liquid will be added into materials to increase flowability of materials, so the capacity is increased. When dry Ball Mill works, capacity is affected because material flowability is reduced, so absorbing wind device is needed on the outlet of Ball Mill, and then negative pressure is formed in the Ball Mill to increase flowability of material, so the capacity is increased.At present, the conventional Ball Mill load-testing program adopts the single-factor or double-factor detection to test the external response of the Ball Mill, according to which direct internal load control will be realized. The main drawbacks of this program exist in the following aspects:1. It tests the external response of the Ball Mill, but cannot accurately determine its internal state.2. Due...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments