Words of Wisdom:

"BMW is the ultimate driving machine" - Bimmer168

The Road to Walk—Hongxing Granite Crusher

  • Date Submitted: 07/10/2013 01:44 AM
  • Flesch-Kincaid Score: 34.4 
  • Words: 493
  • Essay Grade: no grades
  • Report this Essay
Dry of wet material is sent to the hopper through the conveyor belt or bucket elevator , then by hopper of feeding machine goes into the feeding side through feeding pipe. Feeding pipe slope is greater than the natural inclination of the material,which can make the material well go into the dryer convenient.Dryer cylinder is a slightly inclined to the horizontal rotating cylinder .Material goes into cylinder from the higher one end, heat carrier goes into cylinder from the low-end,contacting with the material refluent, but also heat carrier and the material flow into the cylinder together.Mineral ores are blasted down from the mountains; stones that less than 1020 mm are sent into the Vibrating feeder by dump truck; China is a big country in coal production and consumption, but the comprehensive utilization of coal has been uncompleted, and the emission of fly ash has great pollution on environment, which is a waste of resources. In order to protect environment , Hongxing Machinery produced the advanced technology of the domestic and foreign to make this lind of energy saving cone Ball mill .The energy saving cone ball mill is a key equipment to grind the crushed materials, and the energy saving cone ball mill is widely used in powder-making production line including cement, silicate, new-type building material, refractory material, fertilizer, ore dressing of ferrous metal and non-ferrous metal, glass ceramics, etc, and the energy saving cone ball mill can grind various ores and other materials with dry type and wet type. vibrating feeder evenly sends the stone into jaw breaker for primary crushing so that the stone reach in 150 mm-300 mm or so; the materials are sent into Impact breaker for the second crushing by Vibratory feeder , and sorted by vibration screen for screening, the finished products are sent to finished product area by belt conveyor; and the products greater than the materials are sent back to impact breaker for re-crushing.Note: when the...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments