Words of Wisdom:

"This World Is Filled With Evil Tempertantrums And Sonic Explosions" - Dellarh

The Difference Between Jaw Crusher and Counterattack Crusher

  • Date Submitted: 01/20/2014 10:34 PM
  • Flesch-Kincaid Score: 28.9 
  • Words: 346
  • Essay Grade: no grades
  • Report this Essay
Counterattack crusher
Counterattack crusher use scope: can handle length less than 500 mm, less than 350 mpa compressive strength of all kinds of coarse, Vertical Roller Mill In Cement Industry medium and fine materials (granite, limestone, concrete, etc.), widely used in water and electricity, expressway, manual ballast, crushing, etc. Counterattack crusher performance characteristics: unique structure, keyless connection and high chromium plate hammer, unique counterattack plate; Hard rock crushing, high efficiency and energy saving; Product shape is a cube, row partical size is adjustable, simplified crushing process. Counterattack crusher working principle: when work, under the drive of the motor, the rotor high-speed rotation, the material after entering, and rotor plate hammer impact breakage and then be back onto the plate broken again, and finally from the discharging mouth eduction. Grinding Mills For Sale In ZimbabweMill in the production of sand factory or using the most is the jaw crusher. The machine is compared with the other crusher, has low cost, high efficiency, etc.
Jaw crusher
Jaw crusher of wear-resisting requirements are very high, the general selection of material for high wear resistant manganese steel lining plate. The machine work, its crushing cavity inside two jaw (manganese steel), a jaw board is also known as stationary (jaw), it is slightly tilted toward the outside) fixed to the upper crusher cavity fanterior wall, back and forth another jaw is activities we commonly known as (dynamic jaw) is also called the jaw tongue, tilt, coincided with the fixed jaw plate to form a ladder on the small crushing cavity cavity (work). Ultra Wet Grinder Prices In Hyderabad Activity of jaw slabs with fixed jaw crushing take knead reciprocating motion, then separate, then close. Two separate jaw, material immediately into the crushing cavity, this time, already broken good finished product from the bottom of the crusher discharge; When two jaw by...


Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments