Words of Wisdom:

"isn't it wierd when u dream your eating chocolate pudding and u wake up with a spoon in your ass" - Graeffsgirl

General Introduction of Great Wall Jaw Crusher

  • Date Submitted: 03/18/2014 06:57 PM
  • Flesch-Kincaid Score: 68.3 
  • Words: 446
  • Essay Grade: no grades
  • Report this Essay
The jaw crusher is widely used in mining, building materials, chemical industry, metallurgy and so on. It is suitable for primary and secondary crushing of all kinds of minerals and rocks with compressive strength less than 320 MPa.
Jaw crusher is mainly composed of fixed jaw plate which is the anterior wall of the machine frame, movable jaw plate hanging on the shaft, eccentric shaft, vertical links, toggle plate, transmission flywheel, lining boards on the two jaw plates, pull rod with spring, bracket and adjusting block.

Then how does jaw crusher work? the technician of Great Wall Heavy Industry Machinery Co., Ltd,gave a detailed introduction:

When the electro motor drives the eccentric shaft to rotate through the V-belt, the vertical links will go up and down. When it goes up, it will drive the two toggle plates to gradually flatten, thus pushing the movable jaw plate to move close to the fixed jaw plate, and the ores inside the crushing chamber which is formed by the fixed jaw plate and the movable jaw plate will be squeezed, split, bent and finally crushed. When it goes down, the toggle plate and the movable jaw plate will back off with the spring and the pull rod, and the discharging mouth will become larger to discharge the crushed ores. From here we can see that jaw crusher crushes ores in a certain period. For every rotation of the eccentric shaft, half of the cycle is used for crushing, and the other half is for discharging. Production practice has shown that this crushing method is suitable for coarse crushing with low production cost.

According to the width of the feeding mouth of the equipment, it can be divided into large, medium and small type. That whose width of the feeding mouth is bigger than 600 mm is large type, that whose width of the feeding mouth is in the range of 300-600 mm is medium type and that whose width of the feeding mouth is smaller than 300 mm is small type. In the actual production, the maximum feeding size of jaw...


Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments