Do You Know the Features of Dry and Wet Type Rod Mill?

The rod mill is usually in the overflow type, so we also name it overflow ball mill.

Features of the Rod Mill:

1. Adjustable discharging granularity

2. Power saving

3. High efficiency and high yields

Features of Dry rod mill and Wet type rod mill

1.Transmission adopt rolling bearing instead of sliding bearing, great reduce the friction, ease start and power saving a lot.

2. Cone design of discharge end, not only increase the volume, but also force cone side materials separate from steel ball, the closer of out-put end, the smaller diameter of steel ball, and then increase the effect of repeated grinding; As the professional manufacturer of complete sets of mining machinery, such as spiral separator, Henan Hongxing is always doing the best in products and service. ball mill:http://www.hx-crusher.com/

ore beneficiation:http://www.crusher-machine.com/n51.html

3.The using of circular trench liner increasing the contact surface of ball and mineral ore, enhancing the grinding and capacity of mineral ore, reducing energy consumption.

4.Using the whole frame to facilitate civil construction（one construction of a concrete foundation is available）and equipment installation.

Wet type rod mill is a horizontal cylindrical rotating device, outer gear, two chambers, tumbling box. With the hollow shaft screw, materials evenly run into the first chamber through feeder device. The first chamber has ladder liner or corrugated liner, different specification steel ball is inner-built too, Steel ball is lifted to a certain height and then fall off because of centrifugal force based on rotating cylinder, then make impact and grinding materials. After coarse grinding in the first chamber, materials enter into the second chamber through single-compartment plate, with inner flat plate and cement miller's impact effect; materials would be under further grinding. Powder is discharged through discharging grate plate, then grinding processing is finished.

The...