Words of Wisdom:

"We define culture,culture defines us." - Tigris

How to Install the Circular Vibrating Screen Correctly

  • Date Submitted: 07/08/2014 12:15 AM
  • Flesch-Kincaid Score: 56.5 
  • Words: 348
  • Essay Grade: no grades
  • Report this Essay
The circular vibrating screen is also a new kind of highly efficient screening facility which makes circular movements. This type of vibrating screen employs the cylindrical eccentric shaft vibrating machine, with the advantages of reliability, high vibrating strength, highly efficient screening, low noise, easy repair, safe use and so on. It has been widely used in such industries as mining, building materials, traffic, energy resources, chemistry industry and other industries.The vibrating screen mainly consists of vibrating exciter, pulp distributor, screen frame, rack, hanging spring, screen cloth and other components.The installation of circular vibrating screen:1. Beforeround vibrating screen installation, you should check whether the parts are complete or damaged according to packing list. Since the ex-factory, if the circle vibrating screen vibrator has been used more than six months, it must be dismantled and cleaned, with clean lubricating oil used.2. Install the equipment according to Circle Vibrating Screen installation drawing. The supporting chassis must be installed in the foundation flatly, and to support all the dynamic load and static load of Circle Vibrating Screen,   the foundation should have enough stiffness and strength.3. There are lifting eyes in the vibrating screen four corners, lifting holes in the four corners of supporting chassis. You should lift according to the figure, and lifting the vibrating screen directly, hung on the vibrator, is not allowed.4. There should be a 75mm interval among some motionless parts at least, such as the vibrating screen box, hopper, trough and down spouting.5. Make sure that there is a 10mm interval between spring plate and friction damping board of vibrating screen box.6. Choose damping springs according to the free height, with the front or back-end left and right springs used respectively, and their free heights are equal as far as possible, and the error is less than 5mm. After the installation of...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments