Words of Wisdom:

"if arnold is the cal governor, then what will be his next hollywood project" - Ictus5

Key Conditions About Improving the Quality of Crusher Machine

  • Date Submitted: 08/11/2015 02:22 AM
  • Flesch-Kincaid Score: 50.9 
  • Words: 455
  • Essay Grade: no grades
  • Report this Essay
Key Conditions about Improving the Quality of Crusher Machine

Grinding cement will produce a lot of heat, which are detrimental to the quality of cement and the grinding efficiency and have a great impact on the yield. The water is atomized to spray into the crusher machine through the high-pressure air, which affectively takes away the heat from the crusher machine and makes the crusher machine keep cool.

Water is the surface active substance, which can easily make the coalescence with particles realize the disintegration to prevent the material on the crusher machine. The water spraying is determined by the temperature in the crusher machine, which will not spray water below 1000 in general.

In addition, the amount of the spraying water is determined by the temperature of the clinker in the crusher machine, which may be about 1%-2% and makes the water injected in the crusher machine evaporate completely without residual moisture. Both water spraying from the grinding head and from the grinding end are OK. When the temperature of the material in the crusher machine is very high, it is favorable to spray water from the grinding head. Under normal circumstances, spraying water from the grinding end is common.

Spraying water in the crusher machine can increase the production by 5%-10%. The grinding system can control automatically. According to the noise of the crusher machine, it would be the best to use the electric ear method to control the electromagnetic vibrating conveyors or belt conveyors, control the amount of the material in the crusher machine and automatically adjust the material to keep it even. In this way, the amount of the material in the crusher machine can keep the best state which can improve the output.

There is wind speed in the crusher machine so that the powder produced in the grinding process can be taken away promptly by air, which reduces the cushioning effect of the micro powder, improves the grinding efficiency. Besides,...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments