How to Use the Gear Bearing

Shift the use of bearings:


1, consider the variable speed drive bearing appearance and connection size.


2, variable speed drive bearing horizontally placed, can also be vertical or inclined placement. You can reverse the rotation. It can be both positive and negative input and output power (ie reduction or growth).


3, variable speed drive bearing regardless of installation, and its coupling with both the size requirements.


    Recommended use: with the inner ring and the shaft hole d press H7 / h6; do with the pin hole on the drive in the ring press H7 / r6; D and with the outer housing by H8 / h7; transmission output shaft hole The clearance fit with the gap amount is 0.2 ~ 0.5mm. Industrial washing machine pump valve inlet


4, variable speed drive bearing axial positioning: any three laps around the axial positioning, then you do not need the other two axes axial positioning.


5, the rotation orientation; outer ring and inner ring are flat key positioning. Locate the circle is to use the drive.


6, variable speed drive bearing in the radial direction can withstand a small force, but should not bear a greater workload.


7, the transmission ratio, are the transmission ratio according to a first time installation. If other installation, you should calculate the transmission ratio.


8, at the rated speed (1500rpm), the transmission power (Kw) ratio and the required select variable transmission according to bearing type.


9, when the torque as the basis to work, you need to select the appropriate model.


10, consistent with reducer selection and variable speed drive models bearing model.

http://www.skfbearing-china.com/

Tel:00852-55143810
E-mail：info@abt-fag.com  

SKF6205 bearings,FAG6206 bearings,SKF bearings,FAG bearings,INA bearings