Difference Between the Shaker Screen and Hi-G Dryer

Hi-G Cuttings Dryer http://www.kosun.us/drilling-waste-management/hi-g-dryer.html shares the same construction with shale shaker except its base height. The base of High-G Dryer is bigger than shale shaker. The difference between the shaker screen and Hi-G Dryer focuses their processing materials shale shaker processes the drilling mud and the High-G dryer deals with discharged drilling waste separated by solids control equipment.

The drying shaker http://www.kosun.us/drilling-waste-management/hi-g-dryer.html is actually a vibrating dryer sieve, pour shelves 10 °, in order to reduce the loss of liquid. 4 vibrating screen mesh using a three-dimensional detail of the waveform screen, instead of the conventional flat-line screen, three-dimensional structure allows the force of gravity down into the oncoming solid fold groove, away from the projection area, from each of the a fold of the upper solids separation. By thus increasing the amount of fluid, not drown the convex portion, the convex portion to increase the fluid flow capacity. Two layers of fine screen cloth is attached to the upper layer of coarse screen cloth, three screen cloth bonded together, made of corrugated and then bonded to the openings of the board. Waveform overlay screen area than ordinary flat screen area increased by about 40%, compared with flat screen about 2 to 3 fine sieve size. Fluid-handling capacity increased by 70% and not prone to clogging, the treatment effect is very good.

Zero waste discharge still remains a bit away after going through the previous four steps, therefore solidification, thermal desorption, cuttings reinjection and biodegradation will be utilized to push towards the goal as the last step.KOSUN Hi-G Dryerhttp://www.kosun.us/drilling-waste-management/hi-g-dryer.html can recover water- and oil-based mud in drill cuttings with fluid phase down below 10% and remarkable reduction on waste discharge cost. It is especially good at managing oil-based drill cuttings.