How to Lubricate the Rock Crushers?

To use the rock crusher efficiently, we need to know some use tips about the rock crusher,such as how to prolong its working life, how to lubricate the parts to make it work easier. The article will emphasize on the introduction of how to lubricate the rock crusher.Rock crusher can be divided into jaw crusher, impact crusher, roll crusher and so on, which is widely used as primary and secondary crushing equipment to crush material with compression strength. It is widely used in mine, metallurgic industry, chemical industry, building material, highway, railway, water conservancy, etc. The material falls by the feeder hopper within the aircraft, disperses after the tripper the material to all around the yummy treats. The electric motor after the triangle belt impetus eccentric shaft, causes to move the jaw the vertical motion to crush the material, achieved certain granularity less advanced enters the rotation cavity. The material receives the rotor in the rotation cavity and decides the jaw the attrition stave, the stave material discharges from under hopper. This machine may adjust the turnover material granularity through the loose and tight bolt and the addition and subtraction filling piece. Uses the circumference to give the material, broken than for the material scope the jaw machine is big, the yummy treats speed quick and does not stop up. Broken machine compares with the same level specification jaw, its productivity big, the product granularity small, the reduction ratio is big.Lubrication oil enters into connecting rod bearing through the tube which connects bearing bottom. The oil speed in the oil pressing pipeline should not exceed 1-1.2m/s. The oil pump motor and rock crusher motor should be implosive. For large rock crusher, we also use force feed lubrication besides of circulating lubrication. When we use force feed lubrication, the eccentric bearing and connecting rod"s top bearing should be hydro cooled by water. Waste oil can fall down to the rock...