Raymond Mill Operation:

Raymond mill before starting, check all the access doors are closed tightly, check the crushing jaw plate gap machine with feed particle size analysis, adjust the machine speed should approximate the finished product size requirements. According to boot.
1, use the bucket hoist;
2, start the jaw crusher;
3, to have the material hopper, start the analysis machine;
4, the blower is started (empty load starting, until the normal operation after loading);
5, start the Raymond mill host, in starting the engine instant starts the electromagnetic vibrating feeder. Now Raymond mill grinding work is begun.
Raymond mill operation sequence is simple as follows: Start: lifting machine, crusher, machine, fan, host, feeder. Raymond mill machine should be in the following order off the machine:
1, turn off the feeder stop feeding;
2, about a minute after the cessation of the host;
3, blowing off the residual particles after the cessation of blower;
4, finally closing analysis machine. Raymond Mill shutdown sequence is: feeder, host, blower and analysis machine.
Note: enhance the material is transported to the hopper a certain amount, stop the crusher first and then increase, this should be the change in storage. Raymond Mill in normal working hours are not allowed to be gas, to ensure safety in production, milling machine in any part of the occurrence of abnormal noise, or load suddenly increases should immediately stop check, troubleshooting, to prevent serious accidents. Continue to boot must be removed or mill more than expected, when starting current is too large, affecting the start.
  if you want know more about it ,please visit my website:
http://www.mraymondmill.net/