The Actual Condition of the Sand and Stone Industry

 
 
1. Before the users use the Sand washer , they should clean and remove the foreign matters and floating dust in the chute, material discharging pipe and the water container of the sand washer in order to make sure that the water flow cycle of the equipment is smooth.
 
2. Regularly examine and check whether the screws connecting all spare parts of the machine are loose in order to ensure the safety and stability in the operation of all parts.
 
3. Regularly add lubricating grease on the connecting part and the bearings of the machine so as to ensure the flexible operation of the bearings, and at the same time, cleanse the oil grease and spots inside the bearing chamber in order to extend the service life of the sand washer. And what is more, pay attention of conduct real-time monitoring to the temperature of the bearings and the operational condition of all connecting parts during the operational process of the equipment.
 
4. Finally, after the rock washing process finishes, the workers should completely cleanse the surface of the sand washer impeller and dry it in order to avoid oxidizing, otherwise the impeller may be rusty and its use cycle might be shortened.
Hongxing Machinery XS series high-efficient sand washer is researched and manufactured combining the actual condition of the sand and stone industry in our country and adopting advanced technology. This series of sand washer is high in washing ratio, and reasonable in the structural design, and high in processing amount. During the sand washing process, there is only a small amount of sand that is washed away. The driving part of the sand washer is isolated with water and sand, for this reason, the breakdown rate of this equipment is much lower than the frequently-used sand washer and it leads the sand washer equipment in the sand washing technology at home and abroad.
Raymond mill : http://www.hxjq-crushers.com/raymond-mill.html
pendulum feeder :...