Words of Wisdom:

"This site is the greatest!! :-)" - Tester69

The Difference Between Jc Series Jaw Crusher and Pe Series

  • Date Submitted: 11/13/2013 09:21 PM
  • Flesch-Kincaid Score: 57.1 
  • Words: 563
  • Essay Grade: no grades
  • Report this Essay
Most of you know that the JC jaw crusher and PE jaw crusher are blong to the jaw crsher series, which is the main product used in mining machirey. In addition, JC series jaw crusher is a new rock and mineral processing equipment, JC series jaw crusher has the characteristics of high efficiency and low cost, it can crush materials of high hardness and high abrasiveness. And JC series jaw crusher is with the most advanced international crushing technology and manufacturing standards.

However, do you know what the difference between the JC series and the traditional PE series are? if you do not know it, you can read this article. becuse this article will intriduce something about it. The difference mainly display at the following several points:

1. in structure: JC Series jaw crusher apply the modular design, which use the split frame structure that both sides of the plate will be cast through the axle pin rack together. Motor mounted on the rack to reduce the installation space. Nesting population adjustment device is easy to adjust with mechanical control gear. Special bearing structure simplifies the manufacturing process. Split structure makes lifting (including export container shipping) and installation work simple. Especially in the underground tunnel and in the installation of mobile crushing plant,it can better show its superiority. PE series use the overall welding or steel frame, nearly in the case of same production, the weight of the machine is almost more doubled than the JC series jaw crusher, which make it inconvenient to install, lift, maintain.

2.The discharging hole: the discharging hole adjustment range of JC series jaw crusher is: 10 ~ 275 mm, which is much larger than that of the PE series. In some conditions, one JC series Jaw Crusher can replace two PE Series Jaw Crushers.

3. Feeding hole: PE series of inlet width is fixed teeth-sharp teeth (teeth at the end) and activities of the end of teeth-tooth (tooth tip) is calculated from...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments