Words of Wisdom:

"Only dead fish swim the stream" stephen graham " - Whytee

Weather Struck and Cut Pointing in Brick Making

  • Date Submitted: 04/19/2015 11:11 PM
  • Flesch-Kincaid Score: 68.2 
  • Words: 250
  • Essay Grade: no grades
  • Report this Essay
Similar to the previous weather struck joint, except the bed joints are neatly trimmed using a Frenchman or pointing trowel. The most popular joint used today concrete block making machine, where the joint bed is slightly rounded inwards. The mortar should not be pressed in too hard. The tool needed for this job is a rubber hose Diesel drum mixers, an old type bucket handle.

Henan Daswell Machinery Co., Ltd,is a professional manufacturer and trader specializing in the research, development and production of construction machinery for nearly 30 years. Our main products are as follows:Ready-Mixed Concrete Making Plant,brick making machine,concrete block making machine supplier,etc. We will provide you with the best product and service.

This finish of this joint is flush with the brick work egg laying machine, smoothed off with a rag. This finish should only be used for brickwork above water level. This Finish of this joint is recessed. The mortar is formed to a consistence depth of approximately 5 mm. This joint should only be used with a frost resistant brick and is not recommended where the brickwork could be exposed to severe wind driven rain.

This type of joint should be used when the bricks have become uneven over time due to weathering. The joint is pointed by filling the perp joint first and then the bed joint which would be shaped by placing the trowel on the perp joint and angling it downwards to create a smooth finish.

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments