Words of Wisdom:

"make what is not what it one day dreams of being" - Kevin

Ee 372 Final Exam 100% Correct Answers

  • Date Submitted: 08/12/2015 01:08 AM
  • Flesch-Kincaid Score: 72.2 
  • Words: 773
  • Essay Grade: no grades
  • Report this Essay
EE 372 Final Exam 100% Correct Answers
http://homeworkyahoo.com/downloads/ee-372-final-exam-100-correct-answers/
To Buy this tutorial Copy & paste above link in your Brower
EE 372 Final Exam 100% Correct Answers

1.   In process control the desired value of a system is referred to as the__________?


2.   In process control, the term the “process”, whatever it may be, may also be referred to as the ______________.


3.   The device that exerts a direct influence on the process is called the _____________.

4.   Control system objectives should include:


5.   The response criterion that specifies that the amplitude of each peak of each cyclic response be a quarter of the preceding peak is called_________.

6.   The mathematical relationship between the input of a block and the output of that block is known as the __________ __________.

7.   The equation below describes the response of a __________________ order system.
8.   The current through a RTD can cause the RTD to heat up. This factor is accounted for by use of the ____________________.

9.   Type J, T, K, E, S, and R are all thermocouple types. The letter designates_______________.

10.   Since Thermocouple voltages are small, great care should be taken to protect against electrical noise by_________________.


11.   Strain gauges operate based on the change in ___________________ of a metal under stress.

12.   The primary form of ____________ sensor is the accelerometer.

13.   Flow across an orifice plate varies proportionally with the ___________ of the differential pressure.

14.   A rotameter, a moving vane flow meter and a turbine flow meter all place ________________ in the flow of the material.

15.   Elements of final control are:_______________.

16.   A _________________ is required to condition the signal from a computer so that it might interact with process control equipment.

17.   A simple device that can convert mechanical motion to pneumatic...

Comments

Express your owns thoughts and ideas on this essay by writing a grade and/or critique.

  1. No comments