The Operation and Shutdown Sequence of Raymond Mill

The machine adopts the advanced structures of similar products from home and abroad, and gets improved on the basis of Raymond mill s in the same industry. It is more efficient than Ball mill , which also has the advantages of low power consumption, small floor space and one-time investment. The grinding roll presses the ring under the function of RCC tightly, so even if they were grinded to a certain extent, it wouldn’t influence the amount and fineness of finished products. The roll and the ring both have a long replacement cycle, thus the drawback of centrifugal mill is eliminated. The winnower air operates round winnower machine-mill shell-- cyclone separator.
Sequence of operations:
Simple sequence of operations is as followings: start: elevator → crusher → analytical engine → blower → host → feeder.
Shutdown sequence:
Shut down each part according to the followings when the raymond mill stops running.
1 .Turn off the feeder to stop feeding.
2. After about a minute, stop the host.
3 .Stop the blower after the blowing off the the residual powder.
4 .Shut down the analytical engine.
The shutdown sequence of the raymond mill: feeder → host → blower → analytical engine
5 .You are not allowed to arbitrarily refuel when the raymond mill is in normal operation to ensure production safety. If milling machine makes abnormal noise in any part or the load increases suddenly, you should immediately stop the machine to check it. Troubleshoot problems in order to avoid a major accident. The rest material must be removed if you continue to start the machine. Otherwise the power current is too large, which will impact the start.
 
Dryer machine : http://www.crusher-export.com/dryer.htm
china jaw crusher : http://www.ore-mills.com/jaw-crusher.html